Reporting Software Checklist and Productivity Assessment

Two ways to find out what automated reporting is worth to you. Both start with your own data, not a demonstration. Pick the one that matches your question, or forward the white paper to whoever signs off.

FOR IMAGING IT

Reporting Software Checklist

Technical gap analysis. A structured comparison of what your current reporting stack does and does not automate: measurement transfer, DICOM SR coverage, calculations, decision support and integration surface. Run it against any vendor, including your incumbent.

FOR RADIOLOGY LEADERSHIP

Radiology Productivity Assessment

Time and cost modeling. An estimate of the time and money your department can recover by removing manual dictation, based on your own modality mix and study volumes rather than on industry averages.

FOR WHOEVER SIGNS OFF

The white paper

4 Ways to Cut Radiology Reporting Time in Half*. Twelve pages for IT and Radiology Directors: where reporting time goes, and the four ways to win it back. A PDF, no form to fill in.

What happens after you ask

  1. A 30-minute call. We ask what you scan, on which equipment, into which reporting system. No installation, no access to your environment.
  2. A written findings summary. What is already automatable today, what would need mapping work, and what your current stack cannot do. Yours to keep either way.
  3. You decide whether to continue. If the numbers do not justify the change, that is a legitimate outcome and we will say so.

Ask for either one

Pick one under “What would you like?” in the form below. Or email sales@imorgon.net.

Works with PowerScribe 360 and One, Fluency, Epic and your PACS. Installed on premises. We map every scanner and keep it working.

*Auto-filling the scanner’s measurements cut dictation time by up to 40% (University of Pennsylvania, SIIM 2014). That was numbers only, and only one of the four ways.

This website uses cookies.